The feeding tray is widely used in various industries such as batteries, hardware, electronics, medicine, food, connectors, etc. It is a device that solves the feeding of industrial automation equipment.
Commissioning instructions using feed tray:
1. Connect the electric control box to the 220V voltage. If the indicator light is off, check the position of the fuse on the outside of the electric control box to see if the fuse is intact.
2. Connect the electric control box to the voltage of 220, adjust the speed control rotary switch, whether it rotates in the specified direction, observe the speed of the feed tray, slowly become faster, so that the speed of the feed tray reaches your requirements greater than 20% If the voltage is unstable, the feeding tray will appear fast slow.
3. The workpiece can be placed in the feeding tray at one time according to the diameter of the disk. If the workpiece in the feeding tray does cover the chassis, the material will be added immediately.
4. If the speed control rotary switch rotates to the end during the work of the feeding tray, the work is still unable to move, please stop immediately check whether the chassis is faulty.
There are three reasons:
1. Check if there is any breakage of springs in each group;
2. Whether the bolts are loose;
3. The spring leaf needs to be readjusted.
1. Just replace the spring leaf;
2. Tighten the bolt;
3. Adjust the spring leaf.
The use of the feeding tray facilitates the production of electronic factories pharmaceutical enterprises, brings great convenience to the distribution of objects.
Address: Kangmin Road, Economic Development Zone, Xinghua, Jiangsu, China
Mobile:0086 186 0523 8772